Page 2 of comments on How to Replace the Rollers on your Patio Sliding Glass Door


by TipPro

Comments Page 2 of 3:   Previous 1 2 3 Next
» left by CC
from Florida 6 years 183 days ago.
Good article well written. Now to see if it works fairly easily.
» left by Steve Wickens
from San Diego, CA 5 years 352 days ago.
This article saved me from trying things to get that door out which would not have worked - thanks for the informative, useful help! Taking out the stationary unit was the key.
» left by Thomas Gill
from Orlando, FL 5 years 310 days ago.
Very helpful article and explanation on how to replace the rollers. With a little help from my son and only $10 in parts, we were able to replace the rollers which made our door slide so much easier. Thank you.
» left by Greg K
from Merritt Island, FL 5 years 276 days ago.
Excellent article. I already knew how to get the doors out but the advice on adjusting the rollers before you take them out helped alot. Also, I wasn't sure on how to remove the roller but found this to very helpful. Bought $10 worth of rollers at Home Depot (the last 2 I might add) and took about 15 minutes to install and replace the doors.
» left by Robert
from Florida 5 years 214 days ago.
This is a good article. However, I have doors with 2 stationary panels (one on each side of the sliding section - which is inside of the 2 stationary ones. My question is how to remove the slider so I can replace the rollers. Any information on this?
» left by Mike
from Alabama 5 years 196 days ago.
Great add with a little common sence anybody can do this. Thank you very much!
» left by Anonymous
 4 years 336 days ago.
Lowes and Home Depot did not have my rollers, AWESOME LINK! with very reasonable prices. Thanks!
» left by Randall
from NC 4 years 323 days ago.
Lowes and Home Depot did not have the roller unit for my door. I had to replace the rollers only. I also place a small washer on each side of the rollers between the roller and the slot on the unit to deal with spacing issues. I found this article to be very helpful.
» left by Anonymous
 4 years 261 days ago.
Well, Home Depot didn't QUITE have my rollers, however they had ones with a 'catch tab' that was too big, but otherwise fit. Quick tap of the ole grinder and they fit fine. Only took a sec to make the tab smaller. All better.
» left by JT
from Mira Loma CA 4 years 44 days ago.
Good words but I need pictures too...
We want your comments! If you can read this, you don't have javascript enabled, so you can't use this comment system. Please enable javascript.

Comments Page 2 of 3:   Previous 1 2 3 Next